SPI Recommendations for Woven Garments

A list of garments and the typical number of Stitches per Inch recommended for each of them is given below:

WOVEN GARMENTS

Garments	SPI	Comments	Garments	SPI	Comments
Denim Jeans, Jackets, Skirts	7 – 8	Fewer stitches per inch Generally will give a more contrast stitch appearance.	Children’s wear	8 - 10	Usually 8 to 10 SPI is adequate to provide adequate seam strength and at the same time allow for quicker cycle Times.
Twill Pants or Shorts	8 – 10	More stitches per inch Will help minimize seam grinning.	Dresses, Skirts	10-12	Due to many of the operations being lockstitch, usually 10 – 12 SPI is required to provide adequate seam Strength.
Trousers, Dress Pants, Slacks	10-12	On some operations like serge panels, it may be desirable to use a longer stitch length.	Blind-stitch Operations on Slacks, Dresses Skirts, etc.	3-5	A long stitch length is desirable to minimize the dimple or appearance of the needle penetration on The outside of the garment.
Dress Shirt or Blouse	14-20	Using more SPI allows the use of smaller diameter threads that will minimize seam Puckering.	Button-sew (4 hole button)	16	Button-sew machines are cycle machines with a predetermined number of stitches per cycle.
Casual Shirts, Blouses, Tops	10-14	Using more SPI will give more of a tailored stitch Appearance and better seam coverage when surging.	Buttonhole (1/2” purl or whip stitch)	85-90	Generally sewn vertically – approx. 85- 90 stitches with a lockstitch buttonhole Machine.

When setting standards for stitches per inch, you should always keep in mind that more stitches per inch used in a seam requires longer sewing cycles to complete the seam. Longer sewing cycles translates in to higher labor costs and lower production levels. Sewing machine sewing at 5,000 SPM (stitches per minute) at 8 SPI will sew 17.4 yards of seam per minute. Sewing machine sewing at 5,000 SPM at 14 SPI will sew 9.9 yards of seam per minute.

More stitches per inch will also consume for thread per inch of seam. This will contribute to higher seam strength and more elastic seams, but will also increase the consumption of thread required to sew the garment.

Therefore, the recommendations listed above are common stitch levels that provide adequate seam strength but also take into consideration the factors just mentioned.

When sewing knit fabrics, you should always check for excessive “seam grinning” of the seam; and also check for “stitch cracking”. “Seam grinning” occurs when thread stitch balance is too loose allowing the seam to open up too much when stress is applied to it. “Stitch cracking” is checked by applying pressure on the seam in the stitching direction. If the thread tensions are too tight or if you are not using enough stitches per inch, the threads will rupture as stress is applied on the seam. Therefore, the following recommendations have been made for the number of stitches per inch to be used on the following garments.